Berthold MicroPolar LB 566, Руководство пользователя

Страница: 165 / 176

Chapter 10. Error Lists and Device States
MicroPolar (++) LB 566 73
Chapter 10. Error Lists and Device States
The LEDs indicate the device status. Once the errors have been
corrected, the measurement returns to the state before the er-
ror occurred. An acknowledgment is not required.
10.1 Hardware and Error Prompts
Code Error Possible cause
14 Battery voltage Battery power is low, replace im-
mediately,
see Hardware Manual, chapter 5.4
20 Caution!
Ambient tem-
perature too
high! Check operating temperature of
the evaluation unit, permissible
range:
-20 to 60° C
21 HF temperature
out of range Check operating temperature of
the evaluation unit, permissible
range:
-20 to 60° C
32 Parameter
memory
faulty Compatibility check after software
download: A general reset must
be carried out.
39 HF hardware
failure Faulty cable connection between
the motherboard and HF unit.
Check connector on the mother-
board.
Caution! First, disconnect the
evaluation unit from the power
supply!
For all other error messages, please contact the Berthold
Technologies Service.
10.2 Input Error
Error Probable Cause
Value too large Input value is too large
Value too
small
Input value is too small
Table is empty Sampling has been selected without
previous sample measurement
Chart data
faulty The measuring system has determined
faulty chart data during calibration.
No chart data
available The calculated chart data have been deleted
or calibration has not been completed.
Sampling full You have tried to measure more than 30
samples.