Be126 NFPA20 Installation Manual V4XX - 03 Nov - 2018 page 28
28
Section 26.0
– CLEAR THE NUMBER OF STARTS
(select the
[CLEAR N°STARTS]
sub-menu; see 4.0)
Display
Instructions for resetting the two counters (#1 & #2) of the number of starts.
CLEAR N° STARTS?
[
←
]
YES NO
[
→
]
HOLD LEFT 5SEC
CLEAR N° STARTS
DONE
A) - Push the
[
←
]
push-button for at least five seconds to reset the number of starts counter; a
count down will appear on display before triggering the function.
B) - You can quit the procedure at any time by pushing
[→]
(you exit the function).
C) - After clearing the counters, the display confirms the operation via the message
[CLEAR N° START DONE]
.
Section
27.0 - DISPLAY & LANGUAGE
Push
[MENU]
to open the
Main Menu
. Repeatedly push the
[ ↓ ]
button until you select the
[DISPLAY & LANGUAGE]
menu.
Push
[→]
to open the list of the available options.
Display
Instructions
LANGUAGE (*)
ENGLISH
CONTRAST
75%
A) - Use the
[ ↑ ]
or
[ ↓ ]
arrow to select a function.
B) - Push the
[→]
arrow to enter the function.
C) - Push
[ ↑ ]
or
[ ↓ ]
to choose the proper option or set a numerical value.
NOTE: contrast range is adjustable from 0 up to 100% in step of 5%. A setting of about
75% is suitable for all applications.
(*) English, Italian, Spanish & French.
Section 28.0 - PUSH-BUTTONS TEST
Push the
[OFF]
button to enter the
[
OFF
]
mode of operation. Push the
[MENU]
button to open the Main Menu.
Use the
[ ↑ ]
or
[ ↓ ]
arrow to navigate and select the
[PUSHBUTTONS TEST]
menu. Push
[→]
to enter the menu.
This menu displays the name of the push button that you activate.
Display
Instructions
PUSH-BUTTONS TEST
RIGHT DOWN
START1
START2
TEST
UP LEDS
Note: [OFF],
[MAN] and
[AUTO]
push buttons are active all time (if
you push [AUTO], the Be126 will
enter the AUTO mode).
To exit, push the [ACK] button.
WARNING: THIS PROCEDURE MUST BE CARRIED OUT BY QUALIFIED ONLY PERSONNEL. THE
ENGINE MAY START OR YOU CAN INADVERTENTLY ACTIVATE SOME FUNCTIONS.
The purpose of this tool is to test the efficiency of the push buttons. Normally,
without any push button pressed, the display must indicate the only message
[PUSH-BUTTONS TEST]
. On the left side you can see the position of the messages.
Please note: if you push the
[OFF]
or
[MAN]
or
[AUTO]
button (supposing the button is
working) you will get a change of mode of operation. In other words, these push
buttons are always active. The
[START1]
&
[START2]
push-buttons trigger only a
message on the display. But, using this troubleshooting tool, you can inadvertently
start the engine of activate the crank motor.
