Berner BKE1/1, Руководство по эксплуатации и инструкция

Страница: 14 / 30

Page 13 von 30 13.06.2014
Ver. 2.9 Copyright ©Berner Kochsysteme 2018
Functionality test
BKEA, BKE
The functionality test must be made once the operator knows how to use the unit.
Remove all objects from the basin. Please stop the functionality test should a problem or a
defect occur. Turn OFF the unit and disconnect it.
The unit must NEVER, UNDER NO CIRCUMSTANCES be turned ON without any water
inside the basin!
Once the main switch (power level switch) is turned into ON position the green signal lamp
will light up. With the thermostat knob also in ON position, the heating element will start to
heat up the water contained in the basin. The temperature selection is between 35/50 and
110°C (maximum temperature can be reached only with power level switch on II or
III). Once the selected temperature is reached, the heating will stop.
BKE(S)2/3(E), BKE(S)1/1(E): The device works only with non-tilted heating.
-
Put the basket on the punched bottom plate or into the relative hook of the automatic
basket lift system (optional; if available).
-
Select the desired temperature through the thermostat knob (between 35/50 ° und 110 ° C).
The signal for the heating element (yellow) will light up and the water gets heated.
-
Turn the main switch to OFF position. The signal lamps will turn OFF and the heating will
stop.
If the signal lamp or the touch control panel doesn’t light up, please check the
following:
-
The unit is correctly connected to the mains?
-
The main switch is in ON position?
-
At BKE(S)2/3(E), BKE(S)1/1(E): Heating panned?
BKEA_E, BKE_E
-
When switching on, the software version is briefly displayed „U3.xx“
-
Select the desired temperature with the regulator and 4-digit display ON (a position
between 20
°
and 110
°
C). The operating indicator (yellow) lights up, the water is heated
up.
-
(E) Turn the knob to the 0 position. The heating process stops and the power indicator and
the digital indicator go out.
-
(ESRTN) Switch off the device via the sensor keypad. The heating process is stopped, the
operating display goes out, the digital display continues to display the current temperature
(<20°C). If the temperature is> 20°C, the digital display goes out as well.
Attention
The heating element or the bottom of the basin gets
very hot. In order to avoid risks of burns,
NEVER touch it.