Berner BKE1/1, Руководство по эксплуатации и инструкция

Страница: 15 / 30

Page 14 von 30 13.06.2014
Ver. 2.9 Copyright ©Berner Kochsysteme 2018
Operation
Cooking process
Please fill the basin with sufficient amount of water (the basin must be filled at least with 100
mm of water in height). Never let this amount fall below when using the unit. If this occurs,
an optical error code will appear. The error code can ONLY be reset through disconnection of
the mains. Select the desired power level on the main switch and the desired temperature on
the thermostat knob. After reaching the temperature (the yellow signal lamp will turn OFF),
the unit is ready to use. The green signal lamp means unit ON. Whenever the yellow signal
lamp lights up, the heating element is in function (risk of burns!)
Green signal lamp Unit in function „ON“
Yellow signal lamp Heating element in function „ON“
Red signal lamp BKEA: error code „overheating-
Security thermostat triggered“
Red signal lamp BKE: Warning „Heating panned“
BKEA / BKEA_E / BKEA2/3H / BKEA2/3HE / BKE / BKE_E
Position min. > minimal temperature ca. 35° / ca. 50° Celsius
Position max. > maximal temperature ca. 110° Celsius
Water tap
Attention! The water hardness degree must be between 5-7.
Attention! The water pressure must be below 1 Bar!
To replenish the basin push the blue button with the water tap design
(see image). Water flows until the button gets pushed again.
The water drain tap (standard) is made through a three-way ball
valve under the basin.
Standard water drain:
Turn OFF the unit before draining the water from the basin. Please put a suitable container
under the ball valve or else connect the drain tube with a fixed drain connection. Carefully
open the ball valve to drain the warm water into the container. To replenish the basin again,
push the blue button with the water tap design (see image). Water flows until the button gets
pushed again.
Water drain (WAS) Optional
A fixed connection is necessary. Turn OFF the unit before draining the water
from the basin. Pushing the yellow button (see image), the ball valve will
open automatically. As soon as the basin is empty and to close the ball valve,
push the button again. To replenish the basin again, push the blue button
with the water tap design (see image). Water flows until the button gets
pushed again.
This function also works with the unit turned OFF.
Risk of burns through hot water draining from the basin!