Assembly of the flywheel:
- Move the machine carriage all the way towards
the operator;
- Take out the taper pin from the flywheel shaft
Attention: hammer the pin at the tapered end
(smaller diameter);
- Insert the flywheel so that the manoeuvring handle is at
the top and to the left, as shown in the figure,
compared to the hole for the taper pin.
Check the correct correspondence of the flywheel
shaft sleeve holes.
- Insert the pin into the sleeve as shown in the figure
with the tapered end (smaller diameter) towards the
sleeve itself.
- Hammer the opposite end of the pin (larger diameter)
inserting it all the way.
-
Screw the grain.
P15 Series
Move the machine carriage all the way towards
Take out the taper pin from the flywheel shaft:
hammer the pin at the tapered end
Insert the flywheel so that the manoeuvring handle is at
the top and to the left, as shown in the figure,
Check the correct correspondence of the flywheel
leeve as shown in the figure
with the tapered end (smaller diameter) towards the
Hammer the opposite end of the pin (larger diameter)
10
12-12-
User Manual
-07 UM – CodeF2 - Rev. 0.1
