14
7. Installation
After purchasing your gas bottle you will be ready to set up your gas grill.
a)
Changing the gas bottle shall be carried out away from any source of ignition.
Position the gas bottle at the side of your gas
grill, not underneath, keeping in mind that the bottle must be kept away from heat and in a safe position.
We recommend to guide the hose + regulator through the side opening of the cabinet and to connect the LP gas tank standing
outside the cabinet (See fi gure 17)
Figure 17
Be sure that:
- The BBQ will not be moved / transported as long as the LP gas tank is connected.
- Nobody can fall over the LP gas tank or damage the hose
- The LP gas tank is always used straight up
- The LP gas tank is not exposed to direct sunlight
- The LP gas tank is immediately turned off after use. The LP gas tank should be disconnected as soon as the BBQ session is
completely
fi nished
If you still insist to install the LP gas tank inside the cabinet, be sur that :
- The hose is not touching any hot part of the grill above
- The connection is done as prescribed in this manual
- The hose is still of good quality and no gas leaks occur on the hose or the connection parts
- The LP gas tank is immediately turned off after use. The LP gas tank should be disconnected at the end of the BBQ session and
should be removed from the cabinet
b) When ready to use your gas grill, insert the regulator into the gas bottle valve and tighten fi rmly.
The recommended Length of
the hose shall not exceed 1.5m.
▲
WARNING:
Before attempting to light your gas grill you must refer to your lighting instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be faulty in any way do not
attempt to use your gas grill.
When changing your gas bottle, ensure that there are no sources of ignition close by i.e. fi res, cigarettes, naked fl ames etc. Make
sure that the appliance is switched off.
!
Содержание 1032A-KC5B
Страница 3: ...3 2 Exploded View 40 ...
