8
20129019 - Rev
. 3 (01/18)
END USER
12 RECYCLING AND DISPOSAL
The device is primarily composed of:
Material
Component
steel
structural work
PU (polyurethane)
insulation
PE (polyethylene)
water connection washers
ABS (acrylonitrile-butadiene-styrene)
lining and covers
At the end of the device's useful life, these components must be separated and disposed of according to current regu-
lations in the country of installation.
END USER INSTRUCTIONS
Refer to the GENERAL SAFETY INFORMATION and PRECAUTIONS section for safety-related information
13 START-UP
The heater commissioning must be performed by Techni-
cal Assistance Centre personnel.
Under certain circumstances, such as after long periods of
disuse, the user may need to re-start it without involving the
Technical Assistance Centre. Before doing so, perform the
following checks and operations.
- Check that the supply cocks in the domestic water
circuit are all open
- Switch the electricity supply ON at the mains power
switch and at control panel switch (if fitted).
14 TEMPORARY SHUTDOWN
To reduce to the environmental impact and save energy,
in case of brief absences, week-ends, short trips, etc., and
with external temperatures above 0°C, set the heater tem-
perature control, where available, to the minimum value.
b
If the temperature to which the heater is exposed can
fall below 0°C (frost hazard), perform the operations
described in paragraph "Preparing for extended pe-
15 PREPARING FOR EXTENDED
PERIODS OF DISUSE
If the storage cylinder is not going to be used for an ex-
tended period of time, ask the manufacturer’s Technical
Assistance Centre to make the system safe.
16 EXTERNAL MAINTENANCE
Clean the outside of the storage cylinder with a soft cloth
damped in soapy water.
a
Do not use abrasive products, petrol or triethylene.
End user
Via Risorgimento, 23 A
23900 - Lecco (LC), Italy
www.berettaboilers.com
The manufacturer strives to continuously improve all products. Appearance, dimensions, technical
specifications, standard equipment and accessories are therefore liable to modification without notice.
