Beretta EXCLUSIVE GREEN 16 RSI, Инструкция по установке и эксплуатации

Страница: 23 / 100

23
English
This boiler incorporates a new generation of electronic
boards that, by setting/modifying operating parameters,
allow the boiler to be personalised to satisfy various system
and/or user requirements.
The programmable parameters are shown in the table on
the next page.
The parameters must be programmed with the boiler
in the OFF position. To do this, press the
button
until the display shows - - (fig. 42).
During parameter modification operations, the
“select functions” button acts as an ENTER (confirm)
button, the button acts as an ESCAPE (escape)
button.
If no confirmation is given within 10 seconds, the
value is discarded and returns to the previously set
one.
Setting the password
Press and hold down the select functions button and the
button together for about 10 seconds. The display will look
like fig. 43. Enter the password for accessing the
parameter modifications function by turning the domestic
hot water temperature selector to obtain the required value.
The password for accessing the parameter programming
function is located on the back side of the control panel.
Confirm by pressing ENTER.
Modifying parameters
Turn the domestic hot water temperature selector (fig.
44) to sequentially scroll the two-figure codes of the
parameters indicated in the table.
After identifying the parameter you wish to modify, proceed
as follows:
- press ENTER to access the parameter modification
function.
When ENTER is pressed, the previously set value
starts flashing (fig. 45)
- turn the domestic hot water temperature selector to
change the value
- press ENTER to confirm the new value. The digits stop
flashing (fig. 46)
- press ESCAPE to exit.
The boiler returns to the - - (OFF) status.
To reset, press the
button (fig. 42).
Fig. 42
Fig. 44
ENTER ESCAPE
Fig. 43
13
.
PROGRAMMING PARAMETERS
Fig. 45
Fig. 46
parameter value parameter number