9
ASSEMBLY
INSTALLATION
OF
OTHER
BRANDS
OF
ENGINES:
Place the engine on a table. Measure the height (item
B) from the middle of the crank shaft to the table.
Use one of the two shims (3/4" or 1") if required, to
attain the height of 5.25". If more or less height is
needed, use a couple of flat washers.
Install the engine and shims on the stand. Choose the
set of holes that correspond with the holes at the
base of the engine.
The center of the crank shaft must be 5.75" from the
back of the snowblower.
Make sure that the base of the motor is parallel with
the snowblower frame.
Install engine
Install the 2 1/2" pulley (item 2) on the motor shaft as
shown (hub towards the engine) with a 1/4" x 1/4" x 1
3/4" key.
After positioning the engine, the axis must be parallel
as shown in figures 1 and 2 (hold a ruler (A) on the
double pulley (item 3)).
(Use some shims if necessary).
NOTE: It is very important that the pulleys are
aligned (as shown in the two views: back view of
the snowblower (fig. 1) and the top view of the
snowblower (fig. 2).
No adjustments can be made on the bottom
pulley (fig. 1, item 3).
Tighten the set screw firmly.
Figure 2
Top view of snowblower
Figure 1
Back view of
snowblower
AXIS
AXIS
AXIS
AXIS
AXIS
AXIS
Содержание BERCO PIONEER 700455
Страница 26: ...24 PARTS BREAKDOWN NOMENCLATURE DES PI CES ROTATION SYSTEM WITH CHUTE SYST ME DE ROTATION AVEC GOULOTTE...
Страница 28: ...26 PARTS BREAKDOWN NOMENCLATURE DES PI CES SUBFRAME ASSEMBLY SOUS CH SSIS ASSEMBL...
Страница 30: ...28 PARTS BREAKDOWN NOMENCLATURE DES PI CES SNOWBLOWER SOUFFLEUSE...
