Following we are going to explain how to enter the
example described before in the TC507. Please refer
to the pictures shown on the left hand side.
After turning on the TC507 the display (13) appears
empty. Press the key „rmp“ and display (13) reads the
current value of the 1st segment (display (3) reads
segment number). The indicators (12) point to the unit
of the programme value shown (in ramps degrees
centrigrade per hour). The sketch on the left hand side
shows the situation.
Now enter the heat up speed of 250°C/h from our
example using the digit keys (18). The values appear
in the value display (13).
(the flashing segment display (3) points out that you
are currently entering programme values. After 15
seconds without pushing any key the controller quits
the programming mode (display (3) stops flashing).
Press key „rmp“ to get back to programming mode).
Now press key (14) to enter the final temperature
(which is also the dwell temperature) for this ramp.
The corresponding LED in the sketch (15) lights up.
Again, enter the final ramp temperature of 500°C
using the digit keys (18).
As the final value of segment 1 we are going to enter
the dwell time (of the temperature entered before).
Press key (16), the corresponding LED in sketch (15)
lights up. Enter the value of 20 minutes. If you do not
wish a dwell time enter a value of „0“.
We have now completed entering values for segment
1 from our example.
5
Entering a Programme
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
