Bentone 14-36-41396, Инструкция по установке и обслуживанию

Страница: 15 / 40

15
Bentone
4.2 Preparations for installatoin
Check that the burner’s dimensions and capacity range match the current
boiler. The power data on the type sign refers to the burner’s min. and max.
power.
4.3 Distribution of oil
In order to achieve good reliability, it is important that the oil distribution
system is carried out correctly. Please note the following:
• Selection of pipe diameter, pipe length and height difference, (see
Pump instruction).
• Pipelines are laid with a minimal number of glands.
• The pipes are laid so that the oil supply hoses are not exposed to
tensile stresses or bend too much when the burner is swung out or
removed for service.
• The oil filter should be installed so that the filter cartridge can be easily
replaced or cleaned. Self-cleaning filters are recommended for higher
viscosity oils or oils that contain significant contaminants.
• Oil-affected parts shall be selected in materials that can withstand the
physical properties of the medium.
• When installing oil hoses, check that the inlet and return hoses are
fitted on the correct connection on the oil pump. The hoses must be
positioned so that they do not bend or become tensile.
• Bleed the oil system. The oil pump/oil preheater can be damaged by
running dry. The vacuum should not be less than 0.3 bar in the suction
line during start-up.
4.4 Electrical connection
• Before working with the electrical connection, the power must be
disconnected so that the installation is without power.
• Electrical connection must be made in accordance with current
regulations.
• Burners should be connected to an isolator switch.
• Connection must be made according to the wiring diagram, (see
Electrical equipment).
• Fuse is dimensioned as required.
!
Be sure to fill the
burner oil system
before starting it for
the first time.
!
If any electrical connection is used other than that recommended by Enertech,
there may be a danger of damage to property and personal injury.
!
The oil filter must
be installed before
the burner’s oil
pump.