Bentel Security BTEL-GT, Инструкция по установке и эксплуатации

Страница: 21 / 64

G
21
GSM Telephone dialler
<Telephone Number>
C
for <Telephone Number>, type the number that you are calling (up to 16 digits).
Phone Book Management
ATTENTION - To exit from the Phone Book Management menu and go back, press the
D
key.
Write Phone Book
To enter a telephone number, type the following keypad sequence:
?
<Position no.> <Telephone Number>
C
where <Position no.> is a number from to , while <Telephone number> is a number of up to 16 digits. For
example
? C
(the telephone number entered in the phone book in position no. 1 is 3470).
The dialer can store up to 9 telephone numbers, each up to 16 digits long.
Read Phone Book
To check the programmed phone number, type the following keypad sequence:
@
<Position no.>
where <Position no.> is a number from to . If, for example, you want the third programmed telephone
number (position no. 3) displayed, type
@
.
Delete
To delete a programmed phone number, type the following keypad sequence:
A
<Position no.>
where <Position no.> is a number from to . If, for example, if you want to delete the third programmed
telephone number (position no. 3), type
A
.
Superkeys
The BTEL-GT has two SUPERKEYS (the key and the key), which, when pressed for at least 3
seconds, perform specific actions:
— When you press , a call is made to the telephone number stored at position 9 in the phone book and
the speakerphone function is enabled. After 5 minutes and after that at 30-second intervals, a tone is sounded
on the audio channel. To end the call, press or wait for the other party to hang up.
— When you press , a call is made to the telephone number stored at position 9 in the phone book and voice
message no. 7 is played five times. If the call result is not successful (no answer, busy, or unreachable), the
device automatically attempts to call again 5 times (after 1, 2, 5, and 10 minutes). Repeated call attempts can
be ended by the Block Calls option (see the "Block Calls" section) or by activating Input no. 4 (L4).
The SUPERKEY function cannot be enabled if other calls are in progress.
During calls made with Superkeys and the other party can access the User Menu remotely by pressing .
Remote Programming by text message
By sending specific text messages, you can manage some features of the BTEL-GT. For the features, see
the paragraphs below.
Output Management
Open Collector outputs OC1, OC2, and OC3 can be set as Bistable (enabled and disabled with 2 different commands)
or as Monostable (the output is active for its ON Time, after which it returns to standby). Output OC4 is set as Bistable.
If the output is enabled by sending a text message, Confirm Output Activation Enable (if programmed
by the installer) will be sent by text message.