Bentel Security BTEL-GT, Инструкция по установке и эксплуатации

Страница: 19 / 64

G
19
GSM Telephone dialler
USER
NOTE - The BTEL-GT is guaranteed to function only if the device has been installed and
programmed by qualified personnel.
The User menu allows you to use the BTEL-GT. The User menu can be accessed either with the keypad or
remotely. A block diagram of the User menu is shown below. The symbol indicates the menu items that can
be accessed with the keypad; the phone symbol indicates the menu items that can be accessed remotely.
When you are in the user menu, input activations are placed in the queue and handled after
you exit from the menu.
Programming by keypad
The BTEL-GT parameters can be programmed locally with a keypad. For clear and quick programming, a voice
menu provides support. When programming by keypad, select the parameter by pressing a series of keys, and
then enter the value for that parameter. Press the key (the
D
key in the phone book settings menu) to exit from
the current menu and go back (if no keys are pressed, the voice messages for the menu level will be repeated 3
times before returning to the previous level). Press the
C
key to enter the data. If you know the keypad sequence
to press, to speed up programming, you can type the sequence while the voice menu message is being played
without having to wait for the whole message. Pressing the
D
key for 3 seconds from any menu level allows
you to return to standby status. This feature is valid only when exploring the menus or during programming, even
if a voice message from the menu is playing. To return to the menu, you will need to retype the User PIN.
If you use this command during programming, any data entered will be disregarded.
Access the User Menu key by entering the following formula:
A
<User PIN>
C
where <User PIN> is a 5-digit number (the factory default user PIN is 00000).
Access to programming is indicated by the RED LED turning on (see the section "Status LEDs").
IMPORTANT - Keeping the
D
key pressed for 3 seconds does not cancel entry of the User PIN. If
you become aware that the PIN that you are typing is invalid, you need to wait a few seconds for the
operation to be cancelled automatically, or press the
C
key to finish the entry and then try again.
CAUTION - If you enter the User PIN during a call to access the User Menu (yellow LED lit), the key inputs
will not be confirmed by a tone but the code will still be accepted and you will access the menu at the
end of the call. You cannot enter the User PIN at the beginning or end of a call (yellow LED switching).
Remote programming
The user can perform some operations remotely with a PSTN or GSM phone (in this case, it needs to be
a touch-tone telephone). Again, voice instructions are provided to assist with programming. For remote
User Menu
<User Code>
<User Code>
<User Code>
(For different forms of
access see the
respective sections)
for
Dialer
Parameters
Management
for
Block
Calls
for
Change
Code
for
Phone Book
Management
for
Dial
Number
for
Exit
for
Output
Management
for
Monitor
Input
for
Environment
Listen
Management
for
Back
for
Write Phone
Book
for
Delete
for
Read Phone
Book
for
Back
Or: