12
BTEL-GT
Activating an input while the Installer Menu is in operation does not produce voice calls or
programmed text messages; these events are not even placed in the queue for execution after
exiting from the Installer Menu.
Restore Factory Settings
To reset all the factory settings, remove all power supplies from the device, and then press the
,
,
and
D
keys simultaneously, and reconnect the power supply while keeping the keys pressed for approximately
3 seconds. During this process, the RED LED light will be on (see the section “Status LEDs”).
Access to Programming Mode
When turned on for the first time, or when restarting because factory settings were reset, the BTEL-GT asks
which language is to be used, as described below:
?
= Italian,
@
= English,
A
= French,
B
= Spanish
Press the key for the language to use and to confirm your choice, press the
C
key. In order to program
parameters by keypad, an Installer Code must be entered via the BTEL-GT keypad as follows:
A
<Installer Code>
C
where <Installer Code> is a 5-digit number (the factory Installer Code is 11111). If the code entered is
correct, the Installer Menu will open.
IMPORTANT - Keeping the
D
key pressed for 3 seconds does not cancel the insertion of the Installer
PIN; if you become aware that you are typing the wrong PIN, you need to wait a few seconds for the
operation to be canceled automatically, or type the
C
key to finish your entry and then try again.
Access to programming mode is indicated by the RED LED (see the section “Status LEDs”).
Parameters Management
I
n this section you can program the main settings for the BTEL-GT.
Phone Book Management
The dialler is provided from the factory without any programmed telephone numbers.
Write Phone Book
To program a phone number, type the following keypad sequence:
?
?
?
<Position no.> <Telephone number>
C
where <Position no.> is a number from
to
while <Telephone number> is a number of up to 16 digits. For
example:
?
?
?
C
(the telephone number saved in the phone book under position no. 1 is 3470).
The dialler can memorize up to 9 telephone numbers: each number can consist of 16 digits at most.
Read Phone Book
To read the programmed phone number, type the following keypad sequence:
?
?
@
<Position no.>
where <Position no.> is a number from
to
.
If, for example, you want the third programmed telephone number displayed (position no. 3 ) type
?
?
@
Delete
To delete the programmed telephone number, type the following keypad sequence:
?
?
A
<Position no.>
Содержание BTEL-GT
Страница 42: ...42 BTEL GT...
Страница 62: ...62 BTEL GT...
Страница 63: ...F 63 Avertisseur t l phonique GSM...
