BENSON variante 2 series, Инструкция пользователя

Страница: 18 / 38

Ensure that the
electrical
supply is
compatible to
the heater .
ALL HEATERS
ARE
NEUTRALLY
RESET
Caution
The main electrical supply must not be
switched off or disconnected as a method for
stopping the heater, the exception to this is in
the event of an emergency, or when the
heater has been allowed to cool sufficiently
to prevent any damage from being sustained
to the heater or its controls (ie: during
servicing).
Claims for damage will not be considered if
they have resulted from incorrect wiring or
the incorrect use of the heater
Each heater requires a permanent 230V
50Hz 1ph electrical supply, which must be
wired through a fused isolator fitted with a
fuse of the correct rating (see section 7.1).
The correct supply connection points for the
live, neutral, and earth.
Wiring diagrams are also detailed within this
manual, (section 6.0 )
The electrical supply isolator should be
mounted adjacent to the air heater in an
easily accessible position to allow for
servicing isolation, or emergency shut off.
Electrical panel
Warning
Ensure that the mains isolator is turned
OFF
before undertaking any electrical work on the
heater.
Access to the electrical panel is
gained by opening the right hand heater side
panel.
Warning
Ensure that all connections are secure and
that there are no loose strands which could
bridge across the terminals.
A minimum conductor size of 1.0 mm
(diameter) is required.
Caution
When using
CP4 Optimised
Controller
Consideration
should be made
when routing
the cable
between the
control and
heater. Avoiding
where possible
any existing
cables and