BENSHAW ENHANCED KEYPAD, Руководство пользователя

Страница: 19 / 24

Instructions For Panel-Mounting
2.3 Instructions for Panel-Mounting
If the enhanced keypad is to be hand-held, you only need to connect it to the drive
by using the included interconnection cable. See 2.4 on page 18 for more
information.
To mount the enhanced keypad on the front of the host enclosure, perform the
following steps:
1.
Disconnect all power to the drive.
2. Drill mounting holes in the host enclosure using the drilling template
shown in Figure 12 on page 19.
3. Insert a threaded stud into each of the threaded inserts on the reverse side
of the enhanced keypad and tighten finger-tight.
4. Place the enhanced keypad on the enclosure so that the threaded studs slide
through the mounting holes drilled into the enclosure. Hold the keypad in
place so it does not fall while performing the next two steps.
5. Slide an oversized washer onto each of the threaded studs.
6. Screw a locknut on to each threaded stud and tighten with a torque wrench
to 26 in-lb of torque. It is very important to tighten the nuts securely to
preserve the environmental integrity of the host enclosure.
7. Restore power to the drive.
8. The enhanced keypad is now mounted. See the following section for
connecting the keypad to the drive.
17
2 - INSTALLATION