BenQ MW724, Руководство пользователя

Страница: 27 / 80

Operation 27
Operation
Starting up the projector
1. Plug the power cord into the projector and
into a power outlet. Check that the POWER
indicator light on the projector lights
orange after power has been applied.
• Please use the original accessories (e.g.
power cable) only with the device to
avoid possible dangers such as electric
shock and fire.
• If Direct Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically after
the power cord has been connected and power has been applied. See
"Direct Power On" on page 60 for details.
• If Signal Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically
when VGA signal is detected. See
"Signal Power On" on page 60 for
details.
2. Make sure the lens cover is open. If it is
closed, it could become deformed due to the
heat produced by the projection lamp.
3. Press Power on the projector or ON
on the remote control to start the
projector. The POWER indicator light
flashes and stays green when the projector
is on.
The start up procedure takes about 10-20
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Use the focus ring to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan
for approximately 90 seconds before energizing the lamp.
I
I