BENEKOV S16, Руководство по эксплуатации и установке

Страница: 31 / 39

31
8.
7. Boiler operation by user
7.1. Making fire in the boiler
1. Check the water volume in the heating system.
2. Check whether the stop valves between the boiler and the heating system are open.
3. Check the circulation pump functionality.
4. Clean the burner and ash tray drawer.
5. Fill the container with prescribed fuel - see Chap. 3. If the container is equipped with a lid, close the
container after refilling in order to avoid potential false air intake into the burner through the screw
feeding device.
6. Connect the boiler to the mains (400V/50Hz) via power cord with plug.
7. Put the control unit into operation (see separate control unit instruction manual).
8. If the boiler is equipped with automatic ignition (optional), leave the boiler without intervention. The
control unit evaluates the status of the boiler and makes fire (see separate control unit instruction
manual). During the boiler firing and operation the door must be permanently closed.
9. If the boiler is not equipped with automatic ignition, it is necessary to make fire manually (see
separate control unit instruction manual). Using the control unit manual mode deliver the fuel into the
combustion chamber of the boiler. Leave the screw feeding device switched on until the fuel appears in
the burner (2 cm below the edge of the grate). Subsequently switch the screw off, place fire setting
material on the fuel (eg. paper, dry wood chips, PEPO, solid alcohol or other material intended for this
purpose), ignite it and let it flame up (approx 1-2 minutes). Then add a small amount of prescribed fuel
with a shovel to the fire setting material and switch on the fan. In the event that the fire is extinguished,
repeat the manual firing procedure. Close the door and let the fire flame up well (about 3-5 minutes).
1
2
3
4
5
6
7