27
STEP 17
(Work Step Installation)
1. Install the Step Anchors in the desired locations on
the ramp assemblies using the provided M10 hardware.
(See Fig 17.1)
2. Align the Step Anchors with the keyhole slots on the
Work Step. Fit the keyhole slots over the Step Anchors
and drop the step into place.
3. To remove the Work Step, push the Work Step
upwards so that the keyhole slots will be able to fit over the
Step Anchors and pull the Work Step away from the ramp.
Leave the Step Anchors in place for ease of installation of
the Work Step for the next use.
4. To re-install, repeat Step 17 Item 2.
STEP 18
(Hose Cover Installation)
1. Raise ramps to provide ease of installation for this
step.
2. Check fitment of the two floor troughs by placing them
over the hose bundles. The Under Ramp Floor Trough
should be placed under the ramps, with the cutouts facing
the base plates as the hoses from the ramps are routed
through them. The shorter Floor Trough should be placed
in between the Under Ramp Floor Trough and the Power
Unit Console.
3. Once the two troughs are in place, use the Under
Ramp Floor Trough as a template, mark the four mount-
ing holes on the concrete underneath with chalk or crayon
and set aside the floor troughs.
4. Drill four holes at the locations marked with a 5/16”
drill to a depth of 1-1/2”. (See Fig 20.1) Pay attention to
hose positions. DO NOT damage or pierce the hydraulic
or pneumatic hoses.
5. After drilling remove dust thoroughly, insert four plas-
tic concrete anchors in to the holes that were drilled.
6. Replace the floor troughs so that the anchors line up
with the mounting holes on the two floor troughs. Install
four M5 Pan Head sheet metal screws to fasten the floor
troughs to the concrete.
Leveling Bolts
Step Anchor
Work Step
DANGER!
PRIOR TO WORKING UNDERNEATH THE LIFT,
MAKE CERTAIN SAFETY LOCKS ARE ENGAGED TO
PREVENT LIFT FROM UNEXPECTEDLY LOWERING
CAUTION!
BE AWARE OF RAMP POSITION AND PARTS
PROTRUDING FROM RAMPS. INATTENTIVENESS
MAY RESULT IN PERSONAL INjURY.
Fig 16.1
Fig 17.1
Fig 18.1
