20
2. Using chalk or crayon, mark the floor anchor bolt holes
on the concrete. (See Fig. 10.2)
3. Remove the approach ramps and drill each anchor
hole for the approach ramps in the concrete approximately
4” deep using a rotary hammer drill and 3/4” concrete drill-
bit. (See Fig 10.3)
4. After drilling the anchor holes, remove the dust thor-
oughly from each hole using compressed air and/or wire
brush. ALWAYS WEAR SAFETY GOGGLES.
5. Replace the approach ramps and align the holes that
were drilled in the concrete with the anchor holes on the
approach ramps.
6. Assemble the washers and nuts on the anchors then
tap into each hole with a hammer until the washer rests
against the base. (See Fig. 10.4)
6. With the shims and Anchor Bolts in place, tighten nut
three to five turns past finger tight. DO NOT use an impact
wrench for this procedure. (See Fig. 10.5)
STEP 11
(Installing Accessories)
1.
Place the Turnplates in the Turnplate pockets
(Alignment Model Only). Level the Turnplate Pockets as
shown in Step 17 on page 26.
2. Install the Front Tire stops using the Hinge Pins and
C-clips as shown. (See Fig. 11.1)
3. Install the Flip Up Ramps using the Flip Up ramp
Bracket Pins and C-clips as shown. (See Fig. 11.2)
Fig 10.2
Fig 10.3
Mark
Anchor
Holes
Fig 10.4
Fig 10.5
Fig 11.1
Fig 11.2
