31
STEP 11
(Bleeding the Cylinder)
1. Lift must be fully lowered before changing or adding
fluid.
2. Raise and lower lift six times. The cylinder is self-bleed-
ing. After bleeding system, fluid level in Power Unit reservoir
may be low. Add more fluid if necessary to raise lift to full
height. It is only necessary to add fluid to raise lift to full
height.
3. To pressure test, raise lift to full rise and run motor for
approximately 3-seconds after lift stops. This will put pres-
sure on the hydraulic system. Stop and check all fittings and
hose connections. Tighten or reseal if required.
POST-INSTALLATION CHECKLIST
• Posts Properly Shimmed And Stable
• Anchor Bolts Tightened
• Safety / Sheave Pins Properly Attached
• Electric Power Supply Confirmed
• Cables Adjusted Properly
• Safety Locks Functioning Properly
• Check For Hydraulic Leaks
• Oil Level
• Lubrication of Critical Components
• Check For Overhead Obstructions
• Electrical cords and hydraulic hoses tied off and secure
• Ramps Level
• All Screws, Bolts, and Pins Secured
• Surrounding Area Clean
• Operation, Maintenance and Safety Manuals on Site
STEP 12
(Operation)
To Raise Lift:
1. Position vehicle tires in the center of the lowest ramp.
2. Set parking brake.
3. Before raising vehicle, be sure all personnel are clear of
the lift and surrounding area. Pay careful attention to over-
head clearances.
4. Raise the lift to the desired height by pressing the RAISE
push button on the Control Panel.
5. After vehicle is raised to the desired height, lower the
lift until the primary safety engages. Do not allow cables to
become slack. ALWAYS ENSURE THE SAFETY LOCK IS
ENGAGED before entering work area.
To Lower Lift:
1. Before lowering vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances. Ensure all tools and equipment have
been cleared from under the lift.
2. Raise the lift off of the Safety Lock by pressing the
RAISE push button on the Control Panel. Make sure you
raise the lift by at least 2 inches to allow adequate clearance
for the lock to clear.
3. Pull the Safety Handle towards the front of the lift.
4. Press the LOWER push button and HOLD.
5. Hold the LOWER push button until the lift has descend-
ed completely.
WEEKLY MAINTENANCE
1. Lubricate all sheaves with general purpose spray-oil.
2. Check all cable connections, bolts, and pins to ensure
proper mounting.
3. Lubricate Safety Lock pivot points with general pur-
pose spray-oil.
MONTHLY MAINTENANCE
1. Check Safety Locks to ensure they are in good oper-
ating condition.
2. Check all cables for excessive signs of wear.
3. Make a visual inspection of ALL MOVING PARTS and
check for excessive signs of wear.
4. Replace ALL FAULTY PARTS before lift is put back
into operation.
•
NEVER EXCEED THE RATED CAPACITY
of lift.
•
DO NOT USE LIFT
if any component is found to be
defective or worn.
•
NEVER OPERATE LIFT
with any person or equip-
ment below.
•
ALWAYS STAND CLEAR
of lift when lowering or
raising.
•
ALWAYS ENSURE SAFETY LOCK IS ENGAGED
before entering work area.
•
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless safety lock is engaged.
Содержание PL-14000
