16 BEN-E-BIKE INSTRUCTION MANUAL
AMPERUM GmbH
Stuttgarter Str. 72
D-78628 Rottweil
www.ben-e-bike.net
[email protected]
Plug the USB connector into a free USB port of your PC. There's no need for any additional driver
software as this interface uses a standard driver that is already included in the Windows operating
system. As a result, it only takes a few seconds for the interface to be recognized once it has been
connected to your PC.
Connecting the USDB interface to your Ben-E-Bike
Your Ben-E-Bike has a connector between the display and the motor control which you can disconnect
(note: extraction force is rather high!):
Now hook up the USB interface instead of the display.
All Ben-E-Bike's of the first generation with the larger LC-display have the same connector directly on
the display.
The USB interface must not be connected to this LC-display!
Neither the USB interface nor the "MControl" software are suitable for the LC-display!
Starting the "MControl" software
The battery on the Ben-E-Bike must be switched on, so that the motor controller and the interface are
supplied with power.
If the red switch on the battery was already switched on and the battery was not used for more than
30 minutes, the red switch must be switched off and on again after approx. 2 seconds!
