➢
Display
➢
Settings
▪
Setting weekday and time
·
Press the
DAY / TIME
key. When the day is flashing press the
▲
or
▼
key to select the day.
·
Press the
DAY / TIME
key again, then press the + or – key to set the hour.
·
Press the
DAY / TIME
key again, then press the + or – key to set the minute.
·
Press the OK key to confirm the setting.
▪
Setting temperature
·
NOTE:
This setting is only applicable for the temperature in standard heating mode, not for the temperature in
the timer mode. The default set temperature is 20
℃
.
·
NOTE:
The heater only starts working when the set temperature is higher than the room temperature.
·
Press the + or – key to set the temperature, which ranges from 15 to 30
℃
.
·
After the temperature setting has been completed, the display flashes about 5 seconds, then shows the room
temperature.
▪
Setting timer
·
Up to 10 different timer settings can be programmed.
·
Each timer setting has its day, power-on time and power-off time.
·
The maximum duration of each timer setting is 23 hours 50 minutes.
·
If the power-off time of the timer setting falls on the following day, it is unnecessary to set the day-just set the
power-off time.
·
Press the TIMER SET key, the timer number starts blinking (01-10).
·
Press the + or – key to select a timer number.
·
Press the TIMER SET key, the cursor on the left side of the day blinks.
·
Press the
▲
or
▼
key to move the cursor to the corresponding day. Press the + key to add a corresponding day,
