·
Inset Installation (Without spacer)
·
Mark the centre of the opening of fireplace, measure 215.5mm to the left and then again to the right. From there
measure from the floor 560mm up the wall. Once measured, mark the two locations, which are the centre of
fixing screws.
·
Fit two screws into the marked locations and leave approximately 2mm gap (see diagram below)
·
Lift the heater up to the hearth and slide the heater onto the two fixing screws.
·
Flat Wall Installation (With spacer) – Spacer is an optional extra 53mm 018376, 105mm 018384
·
The heater shall be secured to the wall using the 2 keyholes located in the spacer rear by the supplied screws.
·
Fit the two screws into the wall and leave approximately 2mm gap (see diagram below).
·
Fit the heater by lifting and sliding it onto the two screws then lowering it into place.
·
