WARNING:
For indoor use only. Do not use outdoors
. This appliance is only suitable for well insulated spaces or
occasional use.
In order to avoid overheating do not cover the heater.
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to circuit that is regularly
switched on and off by utility.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.
Use the heater in a well-ventilated area. Do not insert or allow objects to enter any ventilation or exhaust
opening. To prevent a possible fire, do not block air intakes or exhaust openings in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
Do not place this heater near flammable materials, surfaces or substances, as there may be a risk of fire.
Keep flammable materials, surfaces or substances at least 1m from the heater outlet of the product.
If the fire is to be placed in front of an existing chimney opening and there is any risk of chimney debris
falling down onto the fire or drafts from the chimney it is recommended that the flue or opening is sealed
off with non-combustible non-fibrous insulation materials. Do not place into an existing fireplace that is
prone to dampness. Should it be necessary to cap and seal the chimney to prevent personal injury, a
professional should be hired to do the work
•
This heater must be used on an AC supply only and the voltage marked on the heater must
correspond to the supply voltage.
•
Do not switch the appliance on until it is properly installed as described in this manual.
•
The heater must not be located immediately below a socket outlet. Do not leave the appliance
switched on when leaving your home or going to sleep.
•
Do not leave unattended when plugged in to the mains supply.
•
This heater is not intended for use by children. Never leave unsupervised children where the heater
is left switched ON (I) or unguarded.
•
Only use the appliance for domestic purposes and in the way indicated in these instructions.
•
From time to time check the cord for damages. Never use the appliance if the cord or any part of the
appliance shows any signs of damage.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•
WARNING:
In order to avoid overheating, do not cover or obstruct the heater in any way.
•
Do not use this heater in the immediate surroundings of a bath, a shower, swimming pool or any wet
area
•
Make sure the connection cord does not touch any hot surfaces.
•
Keep the appliance front at least 100cm (1.0m) from walls and any other combustible materials.
•
Do not use the appliance outdoors
•
Do not use if you have wet hands.
•
Never move the appliance by pulling the cord.
