200697_5
Page 1
Model 1434
(18”) and 1499 (16”) Electric Heater
User instructions for LED effect 2kw Heater
These instructions should be read carefully and retained for future reference
I
mportant
N
otes
•
T
his product is only suitable for well insulated spaces or occasional use
•
D
o not use the heater as a primary heat source
•
T
his heater must not be located immediately below a fixed socket outlet.
•
D
o not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
•
D
o not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of
overheating.
•
D
o not use outdoors
•
T
he heater must be cooled down completely before any maintenance
•
A
fter unpacking, please make sure that the appliance is intact, with no signs of damage caused by
transport. If in doubt, do not use the appliance and contact the
S
ervice
C
entre.
•
D
uring normal operation this appliance will emit noise from the internal fan unit.
•
I
f the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
•
C
hildren should be supervised to ensure that they do not play with the appliance or handset
•
C
hildren of less than 3 years should be kept away unless continuously supervised.
C
hildren aged from 3
years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.
C
hildren aged from 3
years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
•
T
his appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
C
leaning
and user maintenance shall not be made by children without supervision
•
S
ome parts of this product can become very hot and cause burns.
P
articular attention has to be given
where children and vulnerable people are in the vicinity.
•
E
nsure that furniture, curtains and other combustible materials are positioned no closer that 1m from the
front of the fire.
•
D
o not run cord under carpeting, do not cover cord with throw rugs, runners or the like.
A
rrange cord away
from traffic areas and where it will not be tripped over.
•
D
o not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause
electric shock, fire or damage the appliance
•
D
o not block air intakes or exhaust openings in any manner
•
D
o not use on soft surfaces such as a bed, where openings may become blocked
•
I
f this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into
the extension and that the instructions for the extension cable / reel are followed.
•
CAUTION
:
I
n order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
•
T
his appliance must be positioned so that the plug / fused spur is accessible
•
I
n the event of a fault please disconnect the fire from the mains supply
•
W
arning:
T
his appliance must be earthed.
T
he wires in the mains lead connected to this appliance are coloured in accordance with the following code:
G
reen and
Yellow
E
arth
Blue
N
eutral
Brown
L
ive
A
s the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
T
he wire which is coloured
G
reen and
Y
ellow must
be connected to the terminal in the plug which is marked with the letter
E
or by the earth symbol or coloured
G
reen or
G
reen and
Y
ellow.
T
he wire which is coloured
B
lue must be connected to the terminal which is
marked with the letter
N
or coloured
B
lack.
T
he wire which is coloured
B
rown must be connected to the
terminal which is marked with letter
L
or coloured
R
ed.
