200697_5
Page 4
Fig.4
Using the appliance as a portable appliance:
•
Remove from the recess / surround by pulling the bottom towards yourself and removing the top from the recess / surround
•
Affix the two feet / brackets to the bottom of the fire using the existing screws
•
Loosen the screws enough to enable you to slide the bracket into position
•
Once in position tighten the screws to hold the brackets
•
The fire can now be used in another room
*IMPORTANT* This appliance must have the feet / brackets fitted to be used as a portable appliance. These feet / brackets are to prevent the
fire from tipping over.
Preparation for Use
Check that the supply voltage details on your flame effect fire are in accordance with your electrical supply. Your fire is fitted with a plug incorporating a
13 Amp fuse. In the event of replacing the fuse in the plug supplied, a 13 Amp fuse approved by ASTA to BS 1362 must be used. Before switching on,
please read the following operation instructions.
Thermostat
This model is fitted with a thermostat that is mounted on the left-hand side of the heater box control panel (see figure 3).
It can be used to control the heat output to maintain a constant room temperature to suit user requirements. This will ensure that excessive heat is not
produced unnecessarily.
To set the temperature
The dial is marked with numbers to indicate the maximum and minimum temperature positions. Start with setting 9 and when the room has reached a
desired level turn the dial slowly to the
left until the thermostat ‘clicks’ off. The thermostat will then maintain the room temperature at the selected level.
To increase the temperature, turn dial back to the right to a higher setting.
Note: - It is possible that if the room temperature is higher than the thermostat setting it will not come into operation and the heater will
remain off until the temperature of the room cools.
Manual 3 Switch Operation
:
The Flame effect and heat controls are located under the top shelf of the
fire surround on the right-hand side of the heater box as shown in
Fig.3
.
•
The first switch marked with a light bulb controls the lamp and flame effect as shown in
Fig.4
.
•
The next two switches operate the fan convector heater. To use the heater the middle of the three switches marked
O/I
(
O
is off,
I
is on) should
be operated first for 1 kW of heat. The right hand switch also marked
O/I
should be used together with the middle switch to give 2kW of heat.
•
Note
’ lamp’ switch must be in the ‘on’ position for heater to function.
Fig.3
Fig.4
