24
25
OPERATION (CONT.)
User Setting
•
Each button can save 2 settings. (Cleansing, Bidet)
•
Press the User 1 button and Cleansing or Bidet consecutively. Then choose
nozzle position by pressing the FRONT/REAR button and water pressure
level by pressing the LOW/HIGH button. Press User 1 again to save the
setting with a beep.
•
The same applies to saving the User 2 setting.
•
Press User 1 or User 2 while using cleansing or bidet to
operate saved settings.
Side Control Buttons
•
Use side control buttons on the unit when the remote control is
broken or its batteries are dead.
•
Press “cleansing” or “Bidet” to start.
•
Press again to stop. Do not use sharp items to press the buttons.
CLEAN
SING/ST
OP
BIDET/P
OWER
CLEANSING / STOP
BIDET / POWER
Identification
•
This function is useful for public toilets when more
than one unit of this product is installed.
•
To prevent interference among units, the main unit and
the remote control should be set with the same ID.
•
If there is only one unit in the bathroom, you do not need to set an ID.
•
The initial ID of the remote and main unit is “0”.
There are 16 choices in ID (00~15).
How to Set ID (Remote Control)
•
Press the “High” button for 3 seconds and the ID will show
up on display.
•
Press the “High” or “Low” button until your ID appears on
display. (00~15)
•
Press “Stop” to save the ID.
Содержание bio Bidet A8
Страница 1: ...OWNER S MANUAL A8 ...