System indicators
The LEDs that indicate which transmitter has activated the Bellman Visit Flash
Receiver normally have the following meanings.
Orange LED indicates a baby cry transmitter.
Green LED indicates a door transmitter.
Yellow LED indicates a telephone transmitter.
Red LED indicates a fire alarm.
If the green and yellow LEDs blink alternately, this indicates that the Bellman Visit
Flash Receiver is in radio key selection mode. The Bellman Visit Flash Receiver will then
wait for a radio signal from a transmitter in the Bellman Visit System which will adjust the
receiver to the same radio key as the transmitter is tuned to.
Flash light
When the Bellman Visit Flash Receiver is activated, the flash light flashes (2) with a sharp
white light.
The flash head can be rotated to point in the direction required. The flash head can, for
example, be pointed towards a wall to prevent dazzle.
Vibration
The Bellman Visit Flash Receiver can power a BE1270 Bellman Bed-shaker (accessory) con-
nected to the socket . The bed shaker is placed under the pillow to wake the user up
when the Bellman Visit Flash Receiver is activated.
Refer to the user manual for the relevant Bellman Visit transmitter for more information
about vibration patterns.
Power supply
When the LED lights up, the Bellman Visit Flash Receiver is correctly connected to the
power supply.
1
Rotatable reflector
2
Flash
3
Orange LED
4
Green LED
5
Yellow LED
6
Red LED
7
Connector for power supply unit
8
Telephone input for analogue telephone
9
Test button
10
Vibrator output
11
Cable holder
12
Table support
13
Green LED
For further information about the product in English, refer to the
Appendix
.
Troubleshooting in brief
28
29
Problem
Solution
Nothing happens.
Check that the power supply unit is connected correctly.
The LED should light up green.
Check that there is current in the wall socket.
The receiver is not activated.
Check the battery in the transmitters.
Check that the receiver is not placed too far away from the
transmitters by moving it closer to the transmitters.
Check that the receiver is set to the correct radio key. For
further information see
Function/Radio key
.
The receiver signals when no
transmitter is activated.
Change the Radio Key on all units in the system. For further
information see
Function/Radio
key.
CZ
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
SRB
APP
