Bell Phones Excursion 39606, Руководство пользователя

Страница: 18 / 26

When the handset battery voltage level is low, the handset will emit two beeps every 1 minute
while the handset BATT LOW LED indicator will flash.
Return the handset on the base cradle to charge.
PAGING FUNCTION
Press the PAGE button located on the base which simultaneously
sends a signal to the handset. The handset will beep for about 30 seconds.
(Figure 17)
RESETTING THE SYSTEM ID
After replacing the handset battery, the handset lost its system ID and the handset IN USE
LED indicator will flash. In this condition, communication between the handset and base unit
may not be possible.
To reset, place the handset on the charge cradle of the base unit for 5 seconds.
ANSWERING MACHINE OPERATION
The Excursion
®
39606 features a sophisticated Digital Answering System. Incoming
Messages (ICMs), Outgoing Message (OGM) and Memo messages are stored electronically
into digital memory. Messages are accessed instantly and arranged compactly in this
memory. The Excursion
®
39606 can store 15 minutes of messages (ICMs, OGM and Memos
combined).
NOTE:
The maximum Incoming Message (ICM) recording time is 2 minutes.
VOICE MENU SYSTEM
A sophisticated Voice Menu System has been designed and pre-programmed into the
Excursion
®
39606. This system will verbally guide you through key operational procedures.
TIME / DAY STAMP
ICMs and Memo messages are automatically voice-stamped with the current time and day.
NOTE: After power failure, the time / day stamp will be lost. In this case, the time will be
incorrect. Please refer to the INITIAL SETUP section on how to set the system time and day.
SETTING ANSWER ON / OFF
A.
TO TURN ANSWER MODE OFF
1.
In standby mode, press the ANS. ON/OFF button on the base unit.
2.
The Excursion
®
39606 will announce “Answering machine is off.”
NOTE: The Excursion
®
39606 will answer after the 10th ring if the Answering Mode is OFF.
Refer to the REMOTE OPERATION section on how to turn the Answering Mode ON remotely.
B.
TO TURN ANSWER MODE ON
1. In standby mode, press the ANS. ON/OFF button until you
hear
“Answering machine is on.”
SETTING THE RINGS SWITCH (TS / 6 / 2) (Figure 18)
The number of rings before the answering system answers a call can be selected by setting
the RINGS switch on the base unit to:
•
TS -Toll Saver
•
6 - Six rings
•
2 - Two rings (Figure 19)
Toll Saver lets you avoid unnecessary toll charges when calling long distance to remotely
retrieve your messages.
The Excursion
®
39606 can be set to answer the first call on the 6th ring, and all subsequent
calls on the 2nd ring by setting the RINGS switch on the Toll Saver (TS) position.
If your Excursion
®
39606 fails to answer on the 2nd ring, then you know that you do not have