Call transfer between handsets
1) During an external conversation, press
INT
key (other party will be put on hold).
2) Dial the handset number where you want to transfer the call.
3) When the other handset answer, there is internal conversation.
4) To complete the transfer, press key on calling handset.
Intercommunication between handsets
With 2 handsets subscribed to the same base set, intercommunications are possible.
To make an internal call:
1) Press
INT
key followed by the handset number to be called;
2) The called handset rings, press key to answer.
3) Press the same key in both handsets to end a call.
Signalling of incoming call
If during an intercommunication an external call arrives, you will hear an acoustic
signal into the speaker and
EXT
icon will blink on LCD. If you want to answer, close first
the internal call by pressing key, wait for the first ring and press again the same
key to answer to the incoming call.
Multi base configuration
Thanks to GAP profile, it is possible to subscribe the proper handset to some DECT base
station of different model and / or different brand with same profile. Each handset can
be subscribed up to 4 base set.
Subscription of handset to other base
The procedure to be followed is the same described in the “Handset Subscription”
paragraph. If the base where you want to subscribe the handset is different model,
follow its instruction to put base in “Subscription mode”. When you do this, follow the
procedure described in the “Handset Subscription” paragraph from the second to the
last step. Vice versa when you need to subscribe an handset of different model on your
base set, first put TWIST208 base in “Subscription mode” then follow the specific
subscription procedure of the handset (suitable in the relative instructions).
NOTE: In any case you need to know the PIN number of the base where you want to
subscribe an handset.
Once you perform a subscription, is necessary to specify the handset searching type of
the base if manual or automatic.
13
ENG
Conference call
A conversation between handset and external line can be extended to other handset.
To activate conference call, follow the same procedure described for “Call Transfer”
with exception of last item where, instead to press key, hold pressed for 1 second
# key on the caller handset. The conference call will be enabled.
