Belden Miranda KMV-3901, Быстрый старт

Страница: 12 / 27

8
Setting Up Your Multiviewer
Cabling Diagram
Cabling Diagram
Cabling diagram (showing KMV-3911 rear panel)
Step 2: Networking Setup
For the KMV-3901/3911 multiviewer to join a TCP/IP network, it must be configured with an
IP address, a network mask, a gateway, and a system name. In addition, a client PC must be
configured to communicate with the multiviewer. You must also configure any Kaleido-
RCP2 units you may have ordered.
The KMV-3901/3911 is shipped with the following default settings:
Once the networking parameters are correctly configured on all KMV-3901/3911 cards, it
will not be necessary to switch off the Densité frame’s power when installing or removing
cards.
IMPORTANT
If you need to install or momentarily remove a Densité card’s rear module, make
sure to first remove the card itself from its slot.
Do not connect the
KMV-3901/3911 card to the
network until the card’s
networking parameters are
properly set (see
Networking
Setup , on page 8
System IP address 192.168.3.31
Network mask 255.255.255.0
Gateway 192.168.3.1
Note:
If the system IP address of the multiviewer has been changed (i.e. it no
longer corresponds to the as-shipped configuration), it is still possible to
determine the current setting. To determine the IP address of your
KMV-3901/3911 multiviewer, see
Finding the System IP Address and
Application Version , below.