Belden Miranda KMV-3901, Быстрый старт

Страница: 10 / 27

6
Setting Up Your Multiviewer
Changing the Output Resolution
Changing the Output Resolution
To change a display’s resolution from the Densité controller’s local control panel
1 Press the Select button on the front edge of the KMV-3901/3911 card.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the LCD display of the Densité frame’s local control panel.
2 On the local control panel, press the [–] button twice, until RESOLUTION appears on the
LCD display:
IMPORTANT
All KMV-3901/3911 cards within a housing frame must have their output
heads configured with the same refresh rate. If your frame is referenced, then
the heads’ refresh rate must also match the reference signal's refresh rate.
Note:
You can navigate the control menu by using the four buttons located
beneath the display:
• Press the [+] and [–] buttons, to navigate between menu options or
between parameter values.
• Press SEL to access the next menu level. When a parameter value is shown
on the display, modify the value by using the [+] and [–] buttons, and then
press SEL to apply the new value.
• Press ESC to go back to the previous menu level.
• Once you have completed your changes, press the Select button
on the
front edge of the KMV-3901/3911 card to exit the control menu.
Select button
Status LED
Boot LED,
Power LED,
CPU Status LED (other side of board)
SDI LEDs
USB connector (other side of board)