Belden HIRSCHMANN RSR20 Series, Руководство по установке

Страница: 34 / 66

34
Installation RSR20/RSR30
Release 06 07/2021
1.5 Display elements
After the supply voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, various
LEDs light up. The process takes around 40 seconds.
Figure 1: LED display elements
1 – Device status
2 – Port status
1.5.1 Device state
These LEDs provide information about conditions which affect the operation
of the whole device.
Figure 2: Device status LEDs
P - Power (green/yellow LED) Meaning
Glowing green Device variants with 1 power supply unit: Supply voltage is on
Glowing yellow Device variants with 2 power supply units: There is only one
supply voltage (P1 or P2) on
Not glowing Supply voltage is too low
RM - Ring Manager (green/yellow LED)
Glowing green RM function active, redundant port not active
Glowing yellow RM function active, redundant port active
Not glowing RM function not active
Flashing green Incorrect configuration of the HIPER-Ring (e.g. the ring is not
connected to the ring port).
1 2
P
RM
Stand by
R1
R2
Fault