Belden Hirschmann MACH4002 Series, Руководство пользователя

Страница: 47 / 72

Installation MACH4002
Release 16 03/2021
47
2.8 Installing an SFP transceiver (optional)
Prerequisites:
Exclusively use Hirschmann SFP transceivers.
See “Accessories” on page 66.
Figure 18: Installing SFP transceivers: Installation sequence
Proceed as follows:

Take the SFP transceiver out of the transport packaging (1).

Remove the protection cap from the SFP transceiver (2).

Push the SFP transceiver with the lock closed into the slot until it latches
in (3).
2.9 Connecting the supply voltage
Remarks:

Observe the information about the voltages to be connected: “Technical
data” on page 55
 For the AC input of the AC/DC plug-in power units, use a nominal rating
of not more than 16 A - slow-blow characteristic.
WARNING
ELECTRIC SHOCK
Start connecting electrical wires only if all safety requirements listed in
chapter
“Supply voltage” are fulfilled.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
3