- 20 -
OM code table to look up proper code to enter for the boom configuration.
Outrigger / Tire Configuration
Push F1 to scroll through and select appropriate outrigger and tire
configurations.
On tires (No need for outriggers)
NOTE: F2 must be set for either static lifting or creep, if “On tires”
configuration is selected.
On outriggers, extend to 0% (fully retracted)
On outriggers, extend for 50% (half extended)
On outriggers, extend for 100% (fully extended)
Static Load Lifting or Creep on Tires
Push F2 to scroll to either Static Load Lifting or Creep on Tires.
NOTE: If an incorrect OM code is entered, Current OM code will change to
BBBB
. If this occurs, push N (F4 button) and enter a permissible code. An
example of this is if
On Tires
and
Creep
are selected, but the swing angle is
not ±3°, then Current OM will change to BBBB and error message will occur.
5.3 Reeving setup
Reeving setting is to adjust the LMI reeving eaqul to the lifting cable of the cane.
Operators shall carefully adjust the displayed reeving equal to the actual
reeving before start to work.
WARNING
The Reeving must be set equal to the actual Reeving, otherwise the LMI
may not be able to work properly.
