Belden grass valley GV FABRIC, Руководство по установке

Страница: 19 / 45

13
[PRODUCT NAME]
[DOCUMENT TYPE]
Installing the Cage Nuts
7. Attach the frame to the rack by using ten spacer cage nuts, and screw ten M6 pan head
screws - four in the front part of the rack, and 6 in its rear part. The recommended torque is
6.55-7.35 Nm. See figure above.
8. Place the frame in the cabinet.
Attaching the Frame to the Rack
9. Remove the blank cover from the selected slot in the frame, and mount the system by
sliding its mounting blades into the frame. Repeat this step to install an additional system in
the other side of the frame, if needed.
10. Tighten the capture nuts to secure the system in the frame. The recommended torque
on the right screw is3.0-3.36 Nm while on the left screw recommended torque is 0.89-0.98
Nm.
Sliding the System's Blades in the Rails
IMPORTANT: Do not remove both of the blank covers at the same
time. When no system is installed, at least one of them should be
present to support the frame's partition.