41
Step 12 Direction of count
In this application the direction of
count will determine whether a cable
movement is shown as a positive or
negative position and rate. If input A
occurs before input B, a positive
display will result when the BA364D is
programmed to count up.
Select ‘uP’ or ‘dn’ from the main menu
and press
P
to show the existing
setting. Using the
Up
or
Down
button
select ‘uP’ followed by
E
to enter the
selection and return to the main
menu.
Step 13 Reset value
When the remote reset switch is
operated the total display (position) is
required to be set to zero.
Select ‘rSEt UAL’ from the main menu
and press
P
which will show the
current figure with one digit flashing.
Using the
Up
and
Down
buttons to
adjust each digit in turn and the
P
button to transfer control between
digits, enter 0000000.0 Finally return
to the 'rSEt UAL' prompt in the main
menu by pressing
E
.
Step 14 Turn local reset off
In this example the operator must not
be able to zero the total (position)
display from the instrument front
panel. The local reset function should
therefore be turned off.
Select ‘LOC-rSEt’ from the main
menu and press
P
which will reveal if
it is turned ‘On’ or ‘OFF’. Using the
Up
or
Down
button toggle the display
to ‘OFF’ and press E to return to the
‘LOC-rSEt’ prompt.
Step 15 Define the security code
Defining a security code prevents
unauthorised access to the
programme functions. Select 'COdE'
from the main menu and press
P
which will reveal the existing security
code. Using the
Up
and
Down
buttons enter the new code 1209 digit
by digit. The
P
button will transfer
control between digits. When the new
code has been entered, press
E
to
return to the main programme menu.
Step 16 Return to the display mode
Following completion of programming
and calibration, return the BA364D to
the display mode by pressing
E
. All
the programming functions will now
be stored in permanent memory and
will be protected from accidental or
unauthorised adjustment by the
security code.
