4.3 Operate machine
4.3.1
Automatic operation
a Push down “Power” button, power indicator is on, system is electrified
and an initial display is showed.
b Touch “Choice” to enter work display.
c Touch W-Para key to enter parameter setting display, separately set
temperature, pressure and time then touching Return key to return to work
display.
d Select work number of heat pressure, check parameter and see if
correct.
e
Heat
Push down Heat button, heating indicator is on and start to heat.
To stop heating, press Heat button again, heating stops, a heating indicator is
off.
Note: to shorten heat time, can move up plates to heat.
Attention: only after selecting work, then in a position to heat, otherwise PLC alarms.
After PLC alarms, turn power off then re-electrifying.
f
Heat pressure
when temperature reaches at setting, place materials,
push down Heating button, the plates move up, pressing and compensating
press. When setting time is up, the plates automatically move down, a single
cycle of heat pressure is finished.
g
Cool pressure
check whether the parameters are correct. Place
materials, press down
Cooling
button, the mould plates move up, pressing and
compensating press. When setting time is up, the plates automatically move
down. A single cycle of cool pressure is finished.
h If on accident, press Emergency stop button to exit.
Note: Before starting lamination, should adjust a position of photoswitch. When the
mould plates move up at this position, the move speed will slow down to ensure slowly
pressing. It is better to normally adjust a gap between the material on top layer and
plate above it to 5 mm. If materials’ depth is changed, need to readjust the position of
photoswitch. Cool press and heat press are the same.
4.3.2
Manual operation
(1) When doing machine adjustment, all of start/stop of motor of oil pump, the
mould plates up, the mould plates down, start/stop of motor of water pump and
heating of plate of each level are able to operate independently. Above actions
can be done through “Manual” interface
(2) When the machine is running, heat press is in working, if need to manually
operate plates to move up or down, can touch
or
area to pop up the up or down button, so that achieve the plates up or down
through manual operation.
At any time to select Work No., amend Work Para, amend System Para and
carry out Manual operation, all of these need to touch Choice to go into the
relevant display, then enter secret code 2222, pop up 4 selection menus.
Heat Press
Cool press
