Beijer Electronics korenix JetWave 3220v3 Series, Руководство пользователя

Страница: 59 / 141

JetWave 3220v3/3420v3 Series User Manual
Page 50
the same network. In JetWave 3420 default setting, the LAN/WLAN to 3G connection is working
under Router mode as well.
Ethernet 1 Data Rate: Configure the Speed/Duplex of the port Eth 1. The default value, Auto
means Auto-Negotiation. Force speed/duplex is available to setup here.
Ethernet 2 Data Rate: Configure the Speed/Duplex of the port Eth 2. The default value, Auto
means Auto-Negotiation. Force speed/duplex is available to setup here.
Country/Region: Select the country you are installed. The channel number may be different
based on your country.
Spanning Tree:
Spanning Tree Protocol (STP) is a link management protocol for AP which provides path
redundancy while preventing loops in a network. STP allows only one active path at a time
between the access points but establish the redundant link as a backup if the initial link fails.
STP Forward Delay (1~30 Seconds): This is the Forward Delay value of the Spanning Tree
protocol setting. The default value 1 is not comfort to 802.1D STP standard, however, it can
shorten the topology change time. But, once you want to connect with other STP device, for
example the management Ethernet switch, you must follow STP protocol value. The min. time is
range from 4~30.
802.1Q VLAN: Enable or Disable 802.1Q VLAN. With 802.1Q enabled, the packet will attach the
1Q VLAN tag inside. To assign the VLAN ID for each AP profile, you should enable 802.1Q VLAN
first. Here is the global VLAN Enable setup.
Management VLAN ID: This is the management VLAN ID of the device. Only the client within
the same management VLAN can access the device’s management interface. To enable
Management VLAN ID, you must enable “802.1Q VLAN” and assign “VLAN ID” for each AP
profile first.
4.2.2
IP Settings
Use this page to configure the IP related parameters for WAN (Eth 1) and LAN (Eth 2)