11
ULTRALINK ULM2000
5. ULM2000 LEVEL SETTING
To optimally set the level on your ULM2000, the High Gain or Low Gain setting has to be set
to the level of the signal being transmitted (ch. 3.5).
Adjust the gain control in the microphone channel of your mixing console so that the peak LED lights up only
occasionally or never at all. The EQ controls in the microphone channel should be set to mid-travel position
to start with. To get the sound you want, try changing the mic position relative to the sound source or even
move the microphone around in the recording room of your studio. Adjusting the angle at which walls face the
sound source can also be helpful. Only when the desired basic sound has been achieved should you start to
use equalizers and signal processors, if any at all (remember: less is often more!)
6. APPLICATION EXAMPLE
Fig. 6.1 shows how easy it is to use the ULM2000. Simply connect the receiver ULR2000 to your mixing
console.
Fig.6.1: Wiring the ULR2000 receiver and the ULM2000 microphone
7. INSTALLATION
7.1 Installation information
V
Always make sure that the devices are not operated in direct proximity of large metallic surfaces
(radiators, metal racks, reinforced concrete walls and similar).
V
The devices should always be at a height of at least 1 m (3 ft.) off the ground.
V
To assure interference-free reception, ideally there should be no large objects placed between the
transmitter and the receiver. Not only the size but also the type of material play a role in determining
how strong signal interference will be!
7. INSTALLATION
