Operating Instructions
HBP530A-CNC
BA85308
Status 46/04
Rev 07.02.11
Page 7
1.4 Proper Operation
The sawing machine described herein is intended solely for the sawing of metal and metal-
related materials within the capacity dimensions outlined in the data sheet. Consultation
should be taken with the manufacturer before sawing any other material. This machinery
must only be used in an explosion-safe environment. The ambient temperature must stay
between +5°C and+40°C. The installation of a coolin g or heating system (specific
equipment) is necessary by higher or lower temperatures. The machine should never stay
outdoor and must be protected from rain and snow.
This machinery was designed, built and tested in conformance with current health and
safety standards. These standards were also considered in the compilation of
documentation. Under normal operation condition this machinery can be deemed to be
safe assuming the safety instructions are considered and the given warnings are heeded.
For proper operation please observe the following points:
•
Operators must be aware of the potential risks and hazards as well as the safety
equipment incorporated in this machinery.
•
Safety equipment, such as emergency stops and covers, must not be removed or
rendered inoperative.
•
In front and behind of the sawing machine are to place if necessary tables, roller tables
and containers that no pieces are able to fall down. Proud materials are if necessary to
support.
•
The requirements contained in the Operating Instructions pertaining to operation,
maintenance and servicing of this machinery must be strictly adhered to.
•
Unauthorised alterations or modifications to this machinery are prohibited.
Danger!
Do not reach into the work zone of the machine during operation.
Deviations from normal operation (e.g. increases in power consumption, temperature or
vibration, or unusual noises) indicate that the function of the machinery is impaired. In
order to avoid faults, which could result in immediate personal injury or material damage,
the relevant maintenance personnel should be alerted without delay.
If in doubt, switch the machine off!
Important!
Damage caused as a result of non-adherence to the Operating Instructions
is not covered under warranty.
1.5 The Workplace
The workplace is the area in front of the operator console. The operator should remain at
the workplace when the machine is working.
