BeefEater BSH158SAEU, Руководство по сборке и эксплуатации

Страница: 8 / 24

8
GAS CONVERSION INSTRUCTIONS
UNIVERSAL LPG AND PROPANE INSTALLATION
NOTE: Conversion of this unit to alternate gas must be
carried out by a qualified licensed person and a Certificate of
Compliance must be issued to the owner on completion of the
installation and conversion� Conversion of this barbecue by
unlicenced persons may result in improper functioning of the
appliance, injury, property damage and may affect your ability
to make a claim under the manufacturer’s warranty�
Converting the unit to alternate gas
Gas conversion kits and fitting procedures vary in some
markets� For details of the kit and fitting instructions
appropriate for your market, please contact your local
BeefEater distributor�
Procedure
1. Change the injectors
• To convert to alternate gas it may be necessary to
change the injector size (refer to Gas Specification
Table on page 6)� To change the injectors, first remove
tthe spark electrode and thermocouple from each
burner as required�
• Release the burner from the retaining bracket by lifting
as shown�
• Replace the injector with appropriate size injector
(refer to Gas Specification Table on page 6)�
All injectors are marked with the orifice size�
• Install burner and replace the spark electrode
and thermocouples�
• Repeat for the other 5 burners
When changing gas types it may be necessary to adjust the
valve to achieve the desired turn down setting� This can only be
completed after the connection to the gas supply and leak test
has been conducted�
2. Adjust the turndown setting on the valve
• Light each burner and rotate the control knob to the
lowest setting, then remove the knob from the valve
shaft, and remove the grommet�
• Using a small flat-blade screwdriver adjust the
turndown adjustment screw to achieve a small steady
flame on the burner�
Turndown screw
• Replace the grommet and the knob
• Recheck the operation of the burner at maximum and
turndown
• Repeat procedures for all valves�
Remove injector and replace
with appropriate size injector�
Remove burner to
access injector