Beckman Coulter Microfuge 16, Инструкция по эксплуатации

Страница: 34 / 54

PN A49436AG
3-8
Operation
Removal and Sample Recovery
3
Release the
START STOP
key to begin deceleration.
CAUTION
Do not lift or move the centrifuge while the rotor is spinning.
4
When the rotor reaches 0 rpm, the door latch releases automatically.
• Elapsed time is displayed for several seconds after the rotor reaches 0 rpm.
a.
Lift the door to full open position and unload the rotor.
WARNING
Do not attempt to override the door interlock system while the rotor is spinning.
Removal and Sample Recovery
CAUTION
If disassembly reveals evidence of leakage, you should assume that some fluid
escaped the rotor. Apply appropriate decontamination procedures to the
centrifuge and accessories.
1
Pull up on the snap-on lock to remove the rotor lid.
Tubes can be removed from the rotor.
The rotor can be left in the centrifuge for subsequent runs.
2
If desired, turn the rotor tie-down screw to the left (counterclockwise) to release the rotor.
3
Remove the rotor by lifting it straight up and off the drive shaft.