Becker C16, Руководство по сборке и эксплуатации

Страница: 20 / 24

Technical data dia. 58
Tubular drive L50-17 L70-17 L80-11 L80-17* L100-11 L120-11
Model C16
Type C SEF I2
Rated torque [Nm] 50 70 80 80 100 120
Output speed [rpm] 17 17 11 17 11 11
Limit switch range 64 revolutions
Supply voltage 230 V AC / 50 Hz
Connected load [W] 315 430 310 470 354 435
Rated current consumption [A] 1.40 1.90 1.40 2.10 1.56 1.90
Operating mode S2 4 min
Degree of protection IP 44
Min. tube inside diameter [mm] 60
Frequency 868.3 MHz
Emission sound pressure level
[dB(A)] ≤ 70
*) This tubular drive is not yet available.
What to do if...?
Problem Remedy
Tubular drive does not move. Program new transmitter.
Bring transmitter within range of the tubular drive.
Press drive or stop button on transmitter at least five times in
the immediate vicinity of the tubular drive.
Insert battery/batteries correctly in the transmitter or insert new
battery/batteries.
Check electrical connection.
Thermal protection switch in tubular drive has tripped. Wait until
the thermal protection switch in the tubular drive is reactivated.
Running direction on tubular drive cannot be set. Delete limit positions (see chapter Deleting limit positions) and
reset the running direction.
Incorrect running direction after deleting limit positions. Use the master transmitter or the direction switch on the tubular
drive to change the direction of rotation.
Tubular drive stops arbitrarily; cannot be restarted in the same
direction. Tubular drive has detected an increase in load. Briefly run the
curtain in the opposite direction, then continue in the desired
direction.
Tubular drive is overloaded. Use a higher-torque tubular drive.
Delete limit positions, then reprogram limit positions.
Tubular drive is not locking.
Tubular drive automatically approaches the locking point 3
times.
The locking point is not correctly programmed. Reprogram limit
positions.
Tubular drive is not unlocking.
Tubular drive automatically approaches the unlocking point 5
times.
The unlocking point is not correctly programmed. Reprogram
limit positions.
20 - en