Deleting all transmitters (except the master transmitter)
Press the programming button (C) on the master transmitter for 3 seconds.
▻
The LED (D) lights up once to confirm.
Press the programming button (C) on the master transmitter again for 3 seconds.
▻
The LED (D) lights up once to confirm.
Press the programming button (C) on the master transmitter again for 10 seconds.
▻
The LED (D) lights up twice to confirm.
►
All transmitters (except the master transmitter) have now been deleted from the ra-
dio receiver.
Overwriting the master transmitter
Press the programming button on the radio receiver (B) for 3 seconds.
▻
The LED (D) flashes and the radio receiver goes into programming mode for 3
minutes.
Now press the programming button of the new master transmitter for 10 seconds.
▻
This is confirmed by the LED (D) going out.
►
The new master transmitter has now been programmed and the old master trans-
mitter overwritten.
Status display
Meaning
LED (F)
Normal operation
Steady light
Program hand-held transmitter
Continuous flashing
Light barrier (LS) activated
1 flash
Safety edge (SKS) activated
2 flashes
Emergency Stop opened
3 flashes
SKS input defective
4 flashes
14
