Beamreach networks BeamPlex BRU-100, Руководство по установке и обслуживанию

Страница: 9 / 56

Remote Unit Installation Ch. 1 Introduction
Service Utilities Overview
1106333-01
Pre-Production
3
Revision 3
Important Notices
Warning : This device is a radio frequency transmitter. It is required to comply
with FCC RF exposure requirements for transmitting devices. A
minimum separation distance of 8 inches (20 cm) or more must be
maintained between the antenna and all persons during device
operations to ensure compliance with the FCC's rules for Radio
Frequency Exposure. If this minimum distance cannot be
maintained, exposure to RF levels that exceed the FCC's limits may
result. This equipment must not be co-located with any other
transmitting antenna.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Note : Any changes or modifications to this equipment that are not
approved by BeamReach Networks could void your authority to
operate the equipment if such changes or modifications affect the
regulatory compliance specified in
Appendix A .
Remote Unit Models
The BeamPlex Broadband Wireless Access System offers two models of
remote units for CPE, as shown in
Figure 1-1 :