Beam IsatDock DRIVE, Руководство пользователя

Страница: 20 / 32

20
6) Connecting Horn and Mute Wires
Horn Alert Output (If required)
The IsatDock DRIVE provides a BLUE wire
output on the rear cable loom for controlling
an external ringer such as a vehicle horn. The
horn output is an open collector output capable
of sinking up to 120mA current. It CANNOT be
connected to the vehicle horn directly and an
automotive grade relay must be used to control
the horn as shown below.
By default, it only works when the key ignition
is OFF and the IsatDock DRIVE is still ON (by
default, the IsatDock DRIVE will stay on for
20 minutes after the key ignition is turned
OFF). This is to avoid the horn buzzing on an
incoming call while the vehicle is being driven.
Radio Mute Feature
The entertainment mute output connects to
the mute input on your car radio, if the radio
includes a mute function. The entertainment
mute feature automatically mutes the radio
system when you place or receive a call. This
feature needs to be supported by a car radio
that supports in functionality.
NOTE
This output signal from the “Mute” connector sinks a
maximum of 100mA (0.1A) to ground
7) Install External Alert Button (optional)
IsatDock DRIVE provides an additional cable pair
from the rear cable loom, known as the standard
Beam alarm loop. This provides a Normally
CLOSED wire loop, which can be used to connect
to any passive type of button, or relay, or reed
switch in which the action breaks the loop (OPEN)
to activate the alarm state.
Connect the BROWN and GREEN wires either
directly to the button, or it can be extended for
longer runs (up to 45 meters). This alarm loop can
support multiple alarm buttons / switches – wired
in SERIES, whereby any one of these buttons will
OPEN (activate) the loop when pressed.
To properly activate the alarm state, the loop
needs to be OPEN for at least 2 seconds –
(ie. holding down the button for 2 seconds
activates the alarm).
8) Tracking & Alert Configuration (optional)
Tracking & Alert requires the setup of tracking
and/or alerting messages.
Please refer to the Falcon software to enable
and configure Tracking & Alert.
NOTE
If the Beam alarm loop is going to be used
with an external button, remember to enable
this external loop in the Falcon settings. Once
enabled, the loop will be armed and activated
with an open-loop condition.
To avoid false triggering, be sure to have the
normally closed button wired into the alert loop,
before applying power.
coil
NO
NC
C
HORN OUTPUT
HORN
RELAY
12V / 24V
Battery