8
Look foward to it.
Start-up steam with hot water module
Start-up suction
The soaking effect and, thus, cleaning performance can be
increased for heavy soiling by switching the hot water mo-
dule to steam.
INFO:
Do not use on sensitive surfaces or materials.
Switching on “hot water module”
Press button
C
on the control panel to activate the hot wa-
ter module. The symbol
N
on the display begins to l ash.
Pressing button
T4
on the handle for the hot water module
switches the function on and symbol
N
on the display stays
illuminated.
Always use button
T4
on the handle to switch the hot water
module on and off.
The “hot water module”
l ow-through volume can be
adjusted on the control valve
(+/-), which is located under
the control panel.
Suction
Press button
B
on the display to activate suction.
LED
D
for suction turns red. (Suction mode 3 = max.)
Press button
T3
on the handle to switch on suction.
Briel y press button
T5
+ or
T5
on the side to vary suction
power.
MIN = LED
D
turns green
MED = LED
D
turns orange
MAX = LED
D
turns red
Press button
T3
briel y to turn suction off again.
INFO:
As there is liquid in the hose and in the extension pipes du-
ring suction operation, the sucker should not disconnected
immediately after cleaning i nishes.
A short delay (approx. 30 seconds) is required.
B
D
C
N
T3
T4
T5
The "hot water module" flow-through can be adjusted, by
pressing the button (C) in 10% increments. This is indicated
between 010 and 100 in the display.
Display shows 010 = 10% minimum amount of hot water
Display shows 100 = 100% maximum amount of hot water
