b)
3. Rinsing
-
Fill the “Water Only” reservoir with 0.5 litres of
clear tap water
-
Fill the boiler with max. 1 litre of clear tap water
Now connect the appliance to the mains and press
button (A) on the display. The pump runs for approx. 50
seconds. The water shortage alert then sounds, and the
water tap symbol (F) flashes on the display. Now
disconnect from the mains power again by pulling out
the plug.
Place a suitable container under the appliance and open
the drain plug on the underside of the appliance by
turning it to the left (spanner width 13). Drain the boiler
and then re-close the drain plug using a ring or open-
end spanner.
Place a suitable container under the appliance and
open the drain plug by turning it to the left with the
included Inbus key (label blue ring “Water Only”).
Drain the reservoir and then screw the drain plug
back in and tighten slightly.
Symbol (F) Button (A)
Boiler descaling / step 3
Move the appliance gently from side to
side to assist removal of loosened
limescale residue.
Warning:
You must perform steps 3a - 3d twice to rinse out the final residue of
limescale and descaler.
a)
d)
c)
